TracTuff M18 to -6 Male Flare

$29.95

Category:

Description

Same specs as the original Honda joint used on the S2000 F20C/ F22C to route coolant from the block to the oil cooler assembly, and commonly used on K Series engines that were not originally equipped with an oil cooler, to get water/ coolant to the OEM oil cooler. Now available to plumb anything that you might need to get water to.

Please consider the k series thermostat housing port adapter or water pump port adapter (on the water pump) to complete the coolant loop. Both of those products would be a low-side return.

NOTE: The hex sits inside the blocks casting, making it inaccessible once installed, this is NOT an accident. Customers wanted something that was as flush as possible due to a number of RWD turbo manifolds that made this a very difficult install. The product shown below is not completely installed. If you are not a fan of that idea… you should consider my M28 x 1.0 adapter instead. I recommend Loctite 5452 as a fast-cure thread sealant or Loctite 561 if you have 24 hrs. to cure. Loctite 561 may be more readily available, but it is my last recommendation. All must be applied thoroughly into the threads.

Additional information

Weight .5 lbs
Dimensions 2 × 2 × 2 in
AN Size

-6 Male Flare – CNC